Straightforward Spring Charger Plate Door Hanger
Flip a melamine charging plate right into a cute door hanger wreath for spring.
I used to be strolling round at Michael’s the opposite day and fell head-over-heals in love with this charging plate within the Easter part. The intense coloured plaid is simply so cute! Proper then and there I made a decision to show it right into a door hanging so I’d have an excuse to purchase it. LOL.
I’ve made a charger plate right into a door hanger earlier than and it turned out nice. You possibly can see the autumn charger plate wreath right here. It is a enjoyable and straightforward craft venture that just about anybody can do. I’ve bought a couple of suggestions that will help you alongside the best way, so comply with together with the directions and don’t miss the video tutorial on the finish of the put up.
Let me present you learn how to make your very personal spring charger plate door hanging.
Supplies Wanted
Directions
Make sure you watch the video on the finish of this put up when you have any questions on learn how to make this craft.
Step 1- Lower a chunk of scrapbook paper simply barely bigger than the wood rectangle. Apply a skinny layer of Mod Podge to the wooden, then press the scrapbook paper in place, smoothing out any air bubbles.
Step 2- Use sandpaper to sand away any extra paper hanging off the sides of the wooden. This works finest for those who stroke the sandpaper from entrance to again so the paper doesn’t raise up. That is the trick to getting good edges any time you connect paper to wooden. Sanding provides you good edges!
Step 3- Apply a high coat of Mod Podge to the paper to assist it maintain as much as the weather exterior.
Step 4- Make a swag of spring floral stems and use florist wire to carry them collectively within the center.
Step 5- Connect the tip of a chunk of ribbon to the charger plate. Glue the middle of the swag to the ribbon, then fold the ribbon again down over the florals and glue them in place. This would be the hanging loop. Glue an ornamental bow over the underside of the ribbon loop to cover the seams and for additional cuteness.
Step 6- Take away the wire from the ornamental wood choose. When the Mod Podge is dry in your rectangle, glue the boots onto the rectangle, then glue the rectangle onto the charger plate.
A NOTE ABOUT GLUE: I used sizzling glue for this venture, but when your plate might be in a sizzling, sunny space, generally that may trigger the recent glue to soften and your venture will come unglued. If that’s a attainable downside for you, I like to recommend utilizing the E-6000 glue as a substitute. I’ve no hopes that it’s going to get that sizzling on my door this spring… it’s means too chilly right here for that! Waaaaaaaaaa… that’s me crying. I miss heat sunshine.
As soon as the glue is dry, your charger plate wreath is able to hold in your entrance door this spring!
Spring Charger Plate Door Hanger Video Tutorial
Like this venture? Pin it!
