Perler Bead Twine Covers

Give your headphones aptitude and hold them tangle-free by protecting the twine with perler beads.

perler bead headphone cord cover instructions

As we speak I’m sharing a brilliant easy craft that’s actually enjoyable to do. I’m going to indicate you learn how to cowl the twine of a set of headphones utilizing colourful Perler beads, additionally known as hama beads or melty beads.

Usually you utilize these sorts of beads to make a flat design on a pegboard, then iron it to soften the beads collectively. However at present we’re going to make use of them in a very completely different means!

Not solely does protecting the twine make the headphones look brilliant and joyful, but it surely helps hold the twine from getting tangled AND helps determine whose headphones are whose. I’ve no proof but, however I additionally assume it’ll assist the twine last more with out breaking.

I adore it when a craft is cute and helpful!

To make this craft, you solely want just a few issues.

Supplies Wanted

Perler Beads
Scissors
Headphones
Felt or a Shallow Dish
Needle-Nosed Pliers

I like to make use of a bit of felt to position my beads on whereas working in order that they’re much less prone to roll away throughout my desk. You can use a bit of dish or plate or no matter it’s a must to comprise your beads. It’s non-compulsory, however does assist.

Directions

Step 1: Place the tip of a great pair of scissors into the perler bead gap and minimize a slit all over the bead.

headphone cord perler beads cut the bead

Step 2: Place the bead onto the tip of the needle nosed pliers and gently pry open the slit just a bit bit.

Step 3: Slip the bead onto the headphone twine. The slit will mechanically shut up and also you’ll hardly even be capable to inform it was minimize. Maintain including beads till you’ve coated the entire twine to your liking. I ended the place the 2 wires break up to go to every earbud, however you might add perler beads to each of these strands too, if desired.

how to add perler beads to headphone cords

It’s that simple!

I selected a rainbow sample with a white bead in between every shade and I completely LOVE the way it turned out! However simply consider all of the completely different patterns and shade combos you might attempt. So many prospects!

You can too do that identical method to charging cords, and many others. so long as the twine matches into the bead gap. No extra boring cords! Bead all of the cords!